- In stock, ready to ship
- Inventory on the way
Compatibility:
VESC One Wheeled Board
Guaranteed safe and secure checkout!
Shipping Info:
Order today for estimated delivery within 7-14 days.
*Ships directly from Makers PEV
The Little FOCer Fully Assembled Flowglider Box *Charge Only*:
*This product is currently shipping in about two weeks from order date
Description:
A fully assembled flowglider box. This box is wired for a charge only BMS. Battery Harness included.
Motor, IMU(gyroscope) and accelerometer will be pre-calibrated for compatibility with straight rails and a BLDC motor.
Upon arrival, you will still need to do run the motor configuration wizard to recalibrate the Little FOCer to your motor. You *should not* have to recalibrate the IMU and Accelerometer for use in straight rails. Further tuning is recommended as each rider has different preferences and riding styles.
Firmware comes preconfigured with reasonable application settings to get riding on a 15s battery with conservative 63V max voltage and 30amps discharge. Each Little FOCer Fully Assembled Flowglider Box will be test ridden for QA before shipping to the end user.
The Little FOCer Fully Assembled Flowglider Box is NOT A DROP IN REPLACEMENT for ANY PEV. You will still need to acquire a battery w/bms between 48V and 84V for safe operation.
While the fully assembled flowglider box is intended to lower the barrier of entry, it is still a DIY project and utilizing the massive amount of configuration options requires a significant learning curve to operate safely. The open source software does not check or save you from bad or unsafe configurations.
The Little FOCer and latching power switch are not compatible with a BMS that uses a momentary power switch to turn on and provides no keepalive to keep this type of BMS from turning off while riding.
The Little FOCer is VESC compatible and can be managed with VESC-Tool*. Mobile versions of VESC-Tool can be downloaded from your mobile app store. Desktop versions of VESC-Tool can be purchased from https://vesc-project.com/vesc_tool ... or compiled from source https://github.com/vedderb/vesc_tool
Parts List
-
Little FOCer BYOH version
-
latching power switch (yellow, green, blue, red)
-
footpad connector
-
motor power connector
-
hall sensor connector
-
*Updated* XLR charge port
-
*Updated* 16 pin molex
-
72mm x 53mm x 1mm 12W/Mk (gray) Thermal Pad
-
3d printed in clear ABS Flowglider Box MK2 version
-
https://www.thingiverse.com/thing:5325535
-
brass inserts preinstalled
-
3d printed in clear ABS Flowglider Cover MK2 version
-
Aluminum lid with countersunk screw holes
-
7 - M3 x .5 nuts
-
7 - M3 x .5 x 8M (FT) screws
-
13 - 18-8 SS - #2 x 3/8 flat head screws
-
6 - nylon washers
-
16 pin molex Battery Harness
-
Pre-crimped charge lines
*VESC is a registered trademark of Benjamin Vedder