Be the first to write a review
Guaranteed safe and secure checkout!
In Stock and Available for Shipping:
Order now and this item will be shipped out on the next open business day.
PLEASE READ: IT appears that a small number of "Enduro" tires sold by TFL are not the correct size, and are too large and / or warped in some way, preventing correct fit. Please make sure your tire is to spec before ordering VRH! Most people who have Enduro tires the VRH fits fine...if yours does not, then your tire is over the size it should be, and not compatible. All stock GT tires (treaded and slick), as well as other aftermarket tires, work and fit fine. Essentially, you need to make sure any aftermarket tire is not larger in diameter than stock.
IMPORTANT NOTES: Fenders and fender deletes will need to be trimmed or Dremmeled (sanded) in order to clear the swingarm and adjuster bolts. We just cut the fender deletes at an angle on a miter saw (and we did a hack job there, yours could be better) and put them on. The Maghandle is incompatible with the VHR brackets. Rim protectors by TFL fit but the rail must be removed to install the VRH.
Once installed, the VRH system is not returnable.
VRH (Variable Ride Height) System:
Introducing the easiest and quickest way to adjust the ride height on your Onewheel GT stock rails, the Variable Ride Height system by Land-Surf!
With other axle carriers, you can choose one or two positions for a change in height - which isn't all that much adjustability. Plus, to change ride height, you need to spend time at home removing a bunch of screws and even the entire wheel.
But In less than a minute using the VRH you can change your ride height to any one of 7 positions, with each position moving the board up or down by around 7mm. The axle is never fully disconnected from the board, so changes are easy and fast. The system drops the Onewheel Rails up to 1.25" down, and about .25" up from stock).
Riding to a trail via the streets? Drop your ride height for the smooth pavement and then quickly raise it to stock or one step higher for the trails! Fast adjustment, and easy to dial in for your perfect ride, every time.
With the VRH system can you precisely dial in any ride height for the terrain while out on a ride, and changing to a new setting takes less than one minute and only 2 screws! No other ride height adjustment product comes close to this! With all the others, it’s a back-at-home-only procedure and definitely not while out on a ride.
The second hole from the top corresponds to stock ride height. From there you can go up slightly (the top hole), or progressively lower the board over 5 stops (the lower holes) for a full drop of about 1.25" from the stock height at the last setting!
Made from 7075 T6 aluminum for super strength, and then anodized, the VRH not only functions like no other axle carrier, but also looks good doing it! Logos are laser etched, not silkscreened, so they can’t rub off.
A set of 4 custom-made, stainless-steel high strength screws attach the VRH inner brackets directly to the frame, and installation takes only 10-15 minutes. For ease of use, ALL of the screws on the VRH system are M8 threaded and use the same size 5mm hex drive.
Meant to work with stock Onewheel GT rails, but may work on other rails that can use the stock axle carriers.
VRH is fully compatible with Stone Cold Chillers - and they work very well together!
Each order includes:
This package includes:
1 - VRH (Variable Ride Height) System
1 - One Stop Board Shop Sticker Pack
Explore Additional Accessories:
Onewheel GT-S HERE
Onewheel GT HERE