Guaranteed safe and secure checkout!
Order now and this item will be shipped out on the next open business day.
You can check our business hours HERE.
Protect your Onewheel GT-S / GT / XR bearings from water and dust that can cause premature bearing failure or motor damage with Bearing Protection V4. This easy-to-install product requires no disassembly of your board, making it a convenient solution to keep your bearings running smoothly.
With the included cotton swabs, clean the bearings thoroughly, avoiding the use of alcohol or other liquids. Apply the grease all the way around the axle and the hub, and slide the seal around the axle, pressing it all the way against the hub until it is flush. Check the grease every few months by lifting the edge of the seal and pulling it off the axle, and add more grease or re-clean as needed.
Please note that for Onewheel GT installations, you'll need to switch the left and right bearing seals as the motor is reversed compared to the Onewheel+ XR. Install the "Left" seal on the right side of your Onewheel GT and the "Right" seal on the left side to ensure a proper fit.
Don't let water and dust damage your bearings - invest in Bearing Protection V4 and ride with peace of mind.
1 - Set of Bearing Protection for Onewheel GT-S / GT / XR
1 - One Stop Board Shop Sticker Pack
Keep your Onewheel GT / Pint X / Pint running smoothly with these replacement O-Rings for the motor axle - also available for Onewheel+ XR HERE. When replacing your bearings, it's important to also replace the O-Rings to ensure proper sealing and prevent dirt and moisture from entering the motor compartment. A complete Onewheel replacement set requires TWO O-rings, one for each side of the axle. Add two (2) to your cart to ensure a complete replacement set. Don't let worn-out O-rings ruin your ride, replace them today and keep your Onewheel performing at its best!
Onewheel GT-S HERE
Onewheel GT HERE
Onewheel+ XR HERE
Great product Thanks
Best SHOP on the Entire East Coast